Home / Shop / Grinding

1250 Vertical Shaft Impact Mill

Grinding · 1250
1250 Vertical Shaft Impact Mill

Key figures

  • Overall size L×W×H (mm)2800×1820×2806
  • Feed size (mm)20–80
  • Output size (mesh)20–170
  • Finished product rateabout 80%

Figures are for the base model. All models in this family are listed below.

Overview

What it is

The large unit of the vertical-shaft impact mill range: 15–25 t/h, 132 kW, and a 1250 mm rotor class. It takes 20–80 mm feed and reduces it to 20–170 mesh in one pass, for a plant that needs sand or fine product at a rate the 800 and 1000 cannot reach.

What it accepts

Building materials, mining, metallurgy and chemical industry: limestone, clinker, coal and other ores, provided the compressive strength is not above 140 MPa and the moisture content is not above 15%. The feed window here starts at 20 mm, so this is a machine for pre-crushed material rather than run-of-blast rock.

Why it processes a lot

The hammer bars are joined rigidly rather than in the traditional loose arrangement. Working, the rotor's inertia is used to strike the material, giving both the breakage and the velocity it needs — which is what carries this unit to 15–25 t/h for a 132 kW drive.

Why the wear parts last

The body is a combined structure rather than one integral casting, so it takes hard impact without cracking. Each hammer bar can be turned and used on both faces, and the toothed joint between rotor and bar lets the bar be moved outward as it wears, so more of the metal is used before it is scrapped.

Built heavier than the small units

The wear package scales with the duty: 108 liner plates at 19 kg each in a 60 mm liner, hammer bars at 36 kg against 8 kg on the 800, and a 20 mm shell. That is what holds the profile of the crushing chamber at this tonnage — thin liners in a 132 kW machine wear through long before the bar is spent.

Drive and control

A 132 kW motor started on a variable-frequency drive, with a 185 kW cabinet — rated well above the motor so the start and the run are not limited by the cabinet. A thin-oil lubrication station serves the bearings, and the dual-feed hopper splits the feed into the rotor from two sides.

Notes

Output is quoted in mesh: 20–170 mesh is roughly 0.85 mm down to 0.09 mm. A finished product rate of about 80% is the proportion falling inside the target range, so the balance is returned or re-crushed. The 800 and 1000 sizes are listed on a separate card. Technical parameters are subject to change without further notice.

All models

Parameter1250
Overall size L×W×H (mm)2800×1820×2806
Feed size (mm)20–80
Output size (mesh)20–170
Finished product rateabout 80%
Capacity (t/h)15–25
Power (kW)132
Starting methodVariable-frequency start
VFD cabinet (kW)185
Lubrication1 set, thin-oil station
Feed hopper1, dual-feed
Liner plates108 pcs, 19 kg each, high-manganese steel
Hammer bars24 pcs, 36 kg each, high-chrome alloy with tungsten steel rod
Liner thickness60 mm
Shell thickness20 mm

Swipe the table sideways to see every column →

Related equipment

Ball Mills34 modelsWet Pan Mills10 modelsHMM Series Hammer Mills2 models
Prices are quoted per project. Tell us the ore type, the target throughput and the site power supply, and we will confirm the configuration and the delivered price.