Figures are for the base model. All models in this family are listed below.
The smallest unit of the vertical-shaft impact mill range. It takes feed up to 50 mm and reduces it to 20–120 mesh at 3–5 t/h, on an 18.5 kW drive, and it stands on a frame only 1450 mm long — small enough to sit inside a workshop or to be moved between small pits.
Where the tonnage is modest but the product still has to be graded sand or fine material: a small quarry or brickworks, a mine laboratory that needs more than a lab mill, a construction site crushing its own rubble. It is the size to specify when a plant wants to test the product and the market before installing a 800 or a 1000.
Building materials, mining, metallurgy and chemical industry: limestone, clinker, coal and other ores, provided the compressive strength is not above 140 MPa and the moisture content is not above 15%. Feed is capped at 50 mm, so the material has to be pre-crushed — this is not a primary crusher.
The hammer bars are joined rigidly rather than in the traditional loose arrangement. Working, the rotor's inertia is used to strike the material, giving both the breakage and the velocity it needs, so an 18.5 kW motor carries 3–5 t/h instead of the fraction of that a hammer mill of the same power would move.
The body is a combined structure rather than one integral casting, so it takes impact without cracking. Each hammer bar can be turned and used on both faces, and the toothed joint between rotor and bar lets the bar be moved outward as it wears — the same arrangement as the larger sizes, which is where the low running cost comes from on a machine this size.
An 18.5 kW motor on a variable-frequency drive, with a 30 kW cabinet — rated above the motor so the start is not the limiting factor. A thin-oil lubrication station serves the bearings, and the dual-feed hopper splits the feed into the rotor from both sides.
Thirty-two liner plates in high-manganese steel, and twenty hammer bars in high-chrome alloy. The series sheet for this size gives the piece counts and the materials but not the unit weights, so the weights are not quoted here; ask us if you need them for freight.
Output is quoted in mesh: 20–120 mesh is roughly 0.85 mm down to 0.125 mm. A finished product rate of about 85% is the proportion falling inside the target range, so the balance is returned or re-crushed. The 800, 1000 and 1250 sizes are listed on their own cards. Technical parameters are subject to change without further notice.
| Parameter | 600 |
|---|---|
| Overall size L×W×H (mm) | 1450×775×1300 |
| Feed size (mm) | ≤50 |
| Output size (mesh) | 20–120 |
| Finished product rate | about 85% |
| Capacity (t/h) | 3–5 |
| Power (kW) | 18.5 |
| Starting method | Variable-frequency start |
| VFD cabinet (kW) | 30 |
| Lubrication | 1 set, thin-oil station |
| Feed hopper | 1, dual-feed |
| Liner plates | 32 pcs, high-manganese steel |
| Hammer bars | 20 pcs, high-chrome alloy |
Swipe the table sideways to see every column →