Figures are for the base model. All models in this family are listed below.
| Parameter | HST-100 | HST-160 | HST-250 |
|---|---|---|---|
| Max Feed (mm) | 180 | 230 | 270 |
| Discharge Range (mm) | 6–32 | 8–38 | 10–44 |
| Capacity (t/h) | 30–70 | 80–180 | 120–250 |
| Motor (kW) | 90 | 160 | 220 |
Swipe the table sideways to see every column →
Answers drawn from the published model table above. Tell us your ore type and target throughput and we will confirm the configuration.
HST-100 accepts up to 180 mm, HST-160 up to 230 mm, and HST-250 up to 270 mm. Feed size is set by the crushing cavity, so the model must be chosen against your primary crusher's output, not against your run-of-mine size.
HST-100 runs 30–70 t/h on a 90 kW motor. HST-160 runs 80–180 t/h on 160 kW. HST-250 runs 120–250 t/h on 220 kW. Throughput figures are for the base configuration and move with feed gradation, moisture and the discharge setting you run.
Discharge range is 6–32 mm on HST-100, 8–38 mm on HST-160 and 10–44 mm on HST-250. For a gravity or centrifugal recovery circuit the useful target is usually the liberation size of your gold, so the closed-side setting should be chosen with the downstream concentrator, not on its own.
The smallest model, HST-100, starts at 30 t/h, so it suits a plant from roughly 30 t/h upward. For a small hard-rock operation in the 1–5 t/h band, a jaw-plus-roller circuit matches the duty better — the HST series is the secondary and tertiary stage for larger tonnage. Give us your target t/h and we will size the stage for you.
HST is the hydraulic-adjustment machine: three models, 90–220 kW, discharge setting from 6 mm up to 44 mm, used where the closed-side setting has to be changed as ore conditions move. The Symons series is the conventional cone range — six models from a 900 mm (3 ft) mantle and 75 kW upwards — and is the usual choice where a fixed setting is acceptable and capital cost matters more than adjustment range.
Mantle and bowl liner wear parts are supplied from our own factory in Zhengzhou, and we keep supplying them after commissioning. Spare-part lists are issued with the machine order so you can plan the first replacement set before the line starts.
Prices are quoted per project, not published as list prices, because the cavity configuration, motor voltage and drive arrangement change with the site. Send ore type, target throughput and site power supply for a delivered price. Freight is quoted separately.
Jaw Crushers — PE & PEX Series13 models
Symons Cone Crushers6 models
2PG Series Roller Crushers4 models