Figures are for the base model. All models in this family are listed below.
A mobile dry gold separator — a gravity concentrator that replaces water with a high-pressure air stream. The air provides the buoyancy that water would normally provide, so the machine can work where there is no water at all.
The frame is compact and the whole unit is trailer-mounted. Against wet gravity equipment it uses less energy and no process water; with the dust-collection system fitted it runs with zero water discharge.
It was developed for high-grade placer gold in Gobi and desert ground, where a wet plant would need a water source and a settling pond. Running dry removes that constraint and cuts both the operating cost and the up-front capital.
Raw material is loaded into the vibrating bin by a loader or excavator. The bin screens out oversize first; accepted material goes by conveyor into the air-separation shaker. Heavy, gold-bearing concentrate stays in the bed, while the lighter, low-grade material is discharged through the spacer chute to the waste area.
Feed coarse screening, storage bin, feeder, feed conveyor, fine screening, air-separation bed, high-pressure blower, mobile chassis, mechanical shaking system and electrical control cabinet. The complete sequence is electrically controlled and needs one operator.
35.65–40 kW connected, excluding lighting: a 5.5 kW vibrating bin, three 0.55 kW vibrators, three 7.5 kW fans, a 3 kW conveyor and a 3 kW electric hoist. A 90 kW generator set is recommended to run the unit off-grid.


| Parameter | 80–100 t/h |
|---|---|
| Raw ore capacity | 80–100 t/h |
| Vibration bin | 5.5 kW |
| Vibrators | 0.55 kW × 3 = 1.65 kW |
| Fans | 7.5 kW × 3 = 22.5 kW |
| Conveyor | 3 kW |
| Electric hoist | 3 kW |
| Total power | 35.65–40 kW, excluding lighting |
| Generator | 90 kW set recommended |
Swipe the table sideways to see every column →
5–10 t/h Weathered Sand Gold Plant2 models
SF & XJK Series Flotation Machines11 models
XB Series Agitating Vessels9 models