Figures are for the base model. All models in this family are listed below.
A trough feeder driven by an electromagnet instead of a motor and gearbox. It takes material from a hopper, bin or stockpile and delivers it evenly and at a controllable rate into the receiving equipment, and there are no rotating parts, no belts, no bearings in the material path and nothing to lubricate.
The trough carries an armature and hangs on a bank of inclined leaf springs. A coil, energised from single-phase 220 V through a controller, pulls the armature once per half cycle; the springs throw it back. The trough therefore vibrates in a straight line at twice the supply frequency — 6000 cycles a minute on a 50 Hz supply — and throws the material forward in small hops along the trough. Turning the controller down reduces the current, the amplitude and the tonnage without changing anything mechanical, which is what makes the feed rate adjustable while the machine runs.
Anything granular or lumpy up to the maximum input size in the table — 50 mm on the GZ1 rising to 150 mm on the GZ5. Dry, free-flowing material suits it best; sticky or very fine damp material tends to build up on the trough floor.
The trough is a welded steel channel with a replaceable liner on the wear face. The drive sits under the trough: coil and core on the base frame, armature on the trough, leaf springs between them. A set of rubber or spring buffers isolates the vibration from the supporting structure, so the feeder can hang from rods or sit on a frame without shaking the building.
Pick from the feeding capacity first, then check that the maximum lump size fits that model — a wide trough is needed to pass a big lump without bridging, which is why the two rise together. Power is small: 60 W on the GZ1, 650 W on the GZ5, all on 220 V single phase, so a small controller is all the electrical work involved. Total weight is the hanging load on the support rods.
Double amplitude is 1.75 mm and clearance 1.9–2.2 mm across the range. The feeder is supplied without a controller unless one is specified. Technical parameters are subject to change without further notice.
| Parameter | GZ1 | GZ2 | GZ3 | GZ4 | GZ5 |
|---|---|---|---|---|---|
| Feeding capacity (t/h) | 5 | 10 | 25 | 50 | 100 |
| Max. feed size (mm) | 50 | 60 | 70 | 100 | 150 |
| Power (W) | 60 | 150 | 200 | 450 | 650 |
| Voltage (V) | 220 | 220 | 220 | 220 | 220 |
| Double amplitude (mm) | 1.75 | 1.75 | 1.75 | 1.75 | 1.75 |
| Clearance (mm) | 1.9–2.2 | 1.9–2.2 | 1.9–2.2 | 1.9–2.2 | 1.9–2.2 |
| Total weight (kg) | 75 | 155 | 225 | 460 | 656 |
Swipe the table sideways to see every column →
80–100 t/h Mobile Dry Gold Separator1 models
5–10 t/h Weathered Sand Gold Plant2 models
SF & XJK Series Flotation Machines11 models